Location
The water heater is in the utility closet near the back entrance.
Temperature Setting
The water heater should be set to 120°F (49°C). This is pre-set and should not need adjustment.
Do Not Adjust
Do not change the temperature setting unless instructed. Higher temperatures waste energy and pose a scalding risk.
Turning On/Off
Turning On (Arrival)
- Locate the water heater in the utility closet
- Check that the water supply valve is open (handle parallel to the pipe)
- Set the power switch to ON
- Wait 30–45 minutes for the water to reach temperature
Turning Off (Departure)
- Set the power switch to OFF
- Leave the water supply valve open (unless winterizing)
Troubleshooting
| Problem | Cause | Fix | |---------|-------|-----| | No hot water | Power switch is off | Turn on the power switch | | Lukewarm water | Tank not fully heated | Wait 30 minutes after turning on | | Water too hot | Temperature set too high | Check thermostat (should be 120°F) | | Leaking | Pressure relief or fitting | Contact property manager immediately |
Leaks
If you notice water pooling around the water heater, turn off the power switch, close the supply valve, and contact the property manager right away.